PLATE SPACER
P/N P815-3E
NSN 5365 01 279 3476
$MFG LOCKHEED MARTIN
NEW GOV SURPLUS
 
ITEM NAME   SPACER,PLATE
DEFINITION  A flat metal or plastic item of various peripheral shapes having a
             solid (not laminated) cross-section. It is designed to maintain a
             predetermined distance between two surfaces. For round items without a
             hole having a solid rectangular cross-section use DISK, SOLID, PLAIN.
             For round or hexagonal items with only one hole centrally located and
             with the length (thickness) exceeding 25 percent of the outside
             diameter or distance across peripheral flats, see SPACER, SLEEVE. The
             thickness between the two parallel bearing surfaces must be 0.006
             inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across
             the peripheral diameter, or smallest overall outside dimension, or
             must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or
             greater across the peripheral diameter or smallest overall outside
             dimension. For items with a thickness less than those indicated above,
             see SHIM. For items with one hole centrally located conforming to the
             above dimensional criteria use WASHER, FLAT or SPACER, RING as
             applicable. When thickness and/or outside diameter or smallest overall
             outside dimension is designated as a tolerance/dimension the maximum
             dimension will be used to determine compliance. Excludes GASKET;
             INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC
             COMPONENT.
            
 
CHARACTERISTIC                          VALUE
OVERALL LENGTH                          1.970 INCHES MINIMUM AND 2.030 INCHES MAXIMUM    
OVERALL WIDTH                           1.190 INCHES MINIMUM AND 1.250 INCHES MAXIMUM    
CENTER TO CENTER DISTANCE               0.950 INCHES MINIMUM AND 1.010 INCHES MAXIMUM    
BETWEEN BOLT HOLES ALONG                                                                  
LENGTH                                                                                   
OUTSIDE EDGE TO BOLT HOLE               0.580 INCHES MINIMUM AND 0.640 INCHES MAXIMUM    
CENTER DISTANCE ALONG WIDTH                                                               
OUTSIDE EDGE TO BOLT HOLE               0.350 INCHES MINIMUM AND 0.410 INCHES MAXIMUM    
CENTER DISTANCE ALONG                                                                    
LENGTH                                                                                    
BOLT HOLE QUANTITY                      2                                                
III END ITEM IDENTIFICATION             RETROFIT ECP 1257 F-16A-D                        
SPECIAL FEATURES                        ONE HOLE 0.302 IN. MIN AND 0.322 IN. MAX ON ONE  
                                        END AND ONE HOLE 0.365 IN. MIN AND 0.385 IN. MAX 
                                        ON OPPOSITE END; TAB 0.190 IN. MIN AND 0.210 IN. 
                                        MAX ALONG LENGTH AND 1.190 IN. MIN AND 1.250 IN. 
                                        MAX ALONG WIDTH WITH 0.06 IN. BEND,30 DEGREE     
                                        RADIUS                                            
MATERIAL                                ALUMINUM ALLOY 6061                              
MATERIAL DOCUMENT AND                   QQ-A-250/11 FED SPEC SINGLE MATERIAL RESPONSE    
CLASSIFICATION                                                                            
SURFACE TREATMENT                       CHROMATE                                         
SURFACE TREATMENT DOCUMENT              MIL-C-5541,CLASS 3 MIL SPEC SINGLE TREATMENT     
AND CLASSIFICATION                      RESPONSE